Constructing a Pump House FAQ How big does a pump house need to be? Once you have the roof on, you can then paint the building or seal it to protect it from rain, snow, and other weather elements to make it last. Nail it securely to the posts and 2x4 sides. Step 4 - Put on the Roof and PaintĬut the metal siding to size using the tin snips and place it on the top of the 2圆 posts. While this is a simple door, you can experiment by building more advanced doors for a fancier or more-secure pump house. Then, attach two door hinges to one side and secure to the front of the pump house.Īttach a handle you can make a simple one from a block of wood. Line it with the 2x4s as you did with the walls. Step 3 - Build and Attach a Doorīuild a basic square frame that will fit the dimensions of the front opening. Then, line the insides of the walls with insulation to protect against freezing weather. Do this all the way around three sides-the front of the pump house will be a door. If you want a different look, you can use a top, bottom, and middle brace, and nail the 2x4s vertically. Make sure you wear the proper safety gear when using a circular saw, like eye goggles and gloves. Using the circular saw, cut the 2x4 lumber down to the correct lengths and begin nailing lengthwise to the posts. Then, either backfill the holes with dirt and tap until it is secure, or set the posts in quick-dry cement. Set in the posts so they rise about four feet above ground, with the front posts at least six-inches taller than the back posts. A hole at least 24 inches is usually deep enough. Dig the holes below the frost layer in your area. Use the post-hole digger to dig holes four feet apart.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |